DIY - Door Felt Weather Strip - Seal Repair | Page 3 | FerrariChat

DIY - Door Felt Weather Strip - Seal Repair

Discussion in '360/430' started by moritz55, Oct 2, 2015.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.

Page 3 of 3
  1. Jase430

    Jase430 Rookie

    Aug 13, 2017
    1
    #51 Jase430, Aug 13, 2017
    Hi there , just wanting to know if you need to sand off all the old felt before applying the new flocking or can you just give it a light sand then apply ?
     
  2. LeoExotic

    LeoExotic Karting

    Nov 29, 2003
    153
    Manalapan, NJ
    Full Name:
    Leonardo
    #52 LeoExotic, Oct 11, 2020
    Did you disconnect the bettery on your car during drying process? I need to keep my doors open in order.to cure.

    Sent from my LG-H932 using FerrariChat.com mobile app
     
  3. moritz55

    moritz55 Karting

    Oct 14, 2011
    63
    Raleigh, NC
    Full Name:
    Mark Morizio
    #53 moritz55, Oct 11, 2020
    No .. I did not.. I put a cardboard & hard foam wedge in the door jam to keep the button compressed enough to keep the lights off... yet leave the door open enough to let it fully cure...

    If you had to use the battery shut-off switch, I guess that is also a viable option.

    Hope this helps....
     
  4. moritz55

    moritz55 Karting

    Oct 14, 2011
    63
    Raleigh, NC
    Full Name:
    Mark Morizio
    #54 moritz55, Oct 11, 2020
    I did not sand off any old... just clean it good in advance , dab the glue on any bare spots and sprinkle the new over the old and bare spots since it blends quite nicely.
    Once fully cured, vacuum off any loose flocking.
     
Page 3 of 3

Share This Page