dash trim

Hi everyone
I am looking for a source for the rubber edge trim that finished off the gauge cluster aluminum, the car I am working one is torn. But I do not see it listed at any of the normal parts places, any thoughts?

Darryl

 

I may have that material (used)...it was actually applied around the edge of the front grill on my Dino when I bought it. Since I removed my instruments to get `refreshed', I had the opportunity to compare...sure looked the same to me. What length do you need, give or take?

 

Ron, do you have dimensions you might post?
Thank you.

Regards, Alberto

 

Hi Ron
thanks for your response, it takes about 43 inches to get around the dash panel, I will gladly pay you for it. As I have had no luck finding it anywhere so far, that would be great,
How much do want for it ?
Darryl

 

Let me dig it up (should be easy to find...if I remember) and I'll post the length.

 

I have a single piece that's 67 inches long. Almost thought I tossed it when it wasn't in any of the `obvious' locations. This only goes to show...never toss anything that you take off a Dino, because somebody out there probably needs it!

 

Hey Ron
I will buy it, if you will sell it, how much do you want for it.
If you could send it to me at

D & B Enterprises
2869 Lotzgesell rd.
Sequim WA. 98382

I will shoot you a check
Darryl

 

PM/email sent.

 

Any more out there anywhere??