Suspension Shims

Hello,

how many of those suspension shims do i need to adjust the suspension in front and rear? And what sizes? I never done this. I lasercut
10x 1,0mm
10x 1,5mm
10x 2,0mm
10x 2,5mm
10x 3,0mm
10x 3,5mm
10x 4,0mm

Is that enough or did i need more of them or smaller ones? 0,5mm?
____________________
Samy

 

In what way are ya adjusting? Are you lowering or raising the car, if so cant ya wind up or down the collers to raise and lower the car? What are you doing to the suspension that requires new spacers? If ya play with the geometry of the suspension i think the car may need to be set up using suspension geometry alineing devices.

 

No i mean to adjust the suspension parameters like king pin angle, toe, chamber i need to adjust all of it. Of corse i use a suspension geometry device.
___________________
Samy

 

Make more of the smaller ones. I used a lot of them to fine tune...just do 20 though.

 

ok what was the smallest you used? Did i nee 0,5mm or is 1mm good? Ok i also can make more after i begin the adjustment or i messure the shim i need and then make exactly the shim then i dont need to put in many individual shims ... but takes more time. I will see how far i got with my startet set of shims So i make 20 of the 1 - 2mm ones and some 0,5mm or are they already too thin?
_______________
Samy