Removing cam distributor rotor drive | FerrariChat

Removing cam distributor rotor drive

Discussion in 'Technical Q&A' started by snj5, Jan 10, 2004.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.

  1. snj5

    snj5 F1 World Champ

    Feb 22, 2003
    10,213
    San Antonio
    Full Name:
    Russ Turner
    #1 snj5, Jan 10, 2004
    Am about to remove the pin holding the distributor rotor drive to the cam.

    Is the pin directional, or can take out from either side?

    How hard is it to get the pin out?

    How hard is it then to take the rotor drive out of the cam?

    Many thanks
    rt
     
  2. Mike Florio

    Mike Florio Formula Junior

    Jun 19, 2003
    592
    NW Rural Nevada
    Full Name:
    Mike Florio
    #2 Mike Florio, Jan 10, 2004
    I was just playing with one last week, making a distributor machine drive. According to my measurements, it has a straight hole drilled in it, and it accepted a standard roll pin. Be careful, though It is part #108005, and a new one will cost you close to $200!
     
  3. ria

    ria Formula Junior

    Nov 2, 2003
    732
    ohio
    Full Name:
    phill
    #3 ria, Jan 10, 2004
    on my 80 308gtsi NO PIN it is a small bolt maybe 4 mm that holds the rotor in plase.
     
  4. yelcab

    yelcab F1 World Champ
    Consultant

    Nov 29, 2001
    12,661
    San Carlos, CA
    Full Name:
    Mitchell Le
    #4 yelcab, Jan 10, 2004
    Mine was a 4mm solid pin that can be driven out from either side, then the gear just pulls off.
     
  5. snj5

    snj5 F1 World Champ

    Feb 22, 2003
    10,213
    San Antonio
    Full Name:
    Russ Turner
    #5 snj5, Jan 11, 2004
    Woo-Hoo.
    Success.
    Thanks everyone!!
    Russ
     

Share This Page