88 Mondial Reverse problem | FerrariChat

88 Mondial Reverse problem

Discussion in 'Technical Q&A' started by AMBII, Jul 28, 2004.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.

  1. AMBII

    AMBII Rookie

    Jul 28, 2004
    4
    I seem to have a problem since I had my 30 thousand service done. I have difficulties shifting into reverse when the car is hot the gears won't stop spinning (for reverse), but I have no problem with the forward gears. Any Ideas?
    Is the clutch bad?

    Does anyone have any procedures on clutch replacements on 3.2 mondial 88?
     
  2. tifosi

    tifosi F1 Veteran
    Lifetime Rossa

    Sep 5, 2001
    5,382
    texas
    Full Name:
    Tom D
    try going into first and the reverse, also make sure you are also pushing down on the shifter
     
  3. dakharris

    dakharris Two Time F1 World Champ

    Jun 7, 2001
    29,441
    Sleepy Hollow
    Full Name:
    Cavaliere Senzatesta
    There's a rubber gasket where the linkage goes through the tranny. It goes bad and causes a misalignment. It's an age problem.
     
  4. maserati424

    maserati424 Rookie

    Apr 11, 2004
    29
    Berlin, Germany
    Full Name:
    frank gablenz
    Try to put out the air of the slave cylinder of the clutch.
     
  5. AMBII

    AMBII Rookie

    Jul 28, 2004
    4
    Thanks for the replies.
    When shifting into reverse, the lever is being pushed down in fact you can get into 1,2,or3 no problem, but push the lever down and push up and get gear grind.
    Also my linkage seals were just replaced 500miles ago with the 30,000 service.

    Does anyone have any step by step instructions on bleeding the slave cylinder? or any other thoughts on whats going on?
     

Share This Page