why am i still getting suspension warn light ?? | FerrariChat

why am i still getting suspension warn light ??

Discussion in 'Technical Q&A' started by thibaut, Sep 3, 2005.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.

  1. thibaut

    thibaut Formula Junior

    Feb 28, 2004
    530
    London, UK
    Full Name:
    Thibaut A.
    After a few pseudo fixes by my specialist, i had enough an bit the bullet. Approved Dealer changed a shock and actuator.
    Was fine then for a month. Just been for a spin and guess what : bloody light came on again.
    This is killing me. Front actuators look ok - I have checked wiring not getting tangled etc.
    Rear had been replaced.
    This active suspension is a pile of crap, can I just get rid of it altogether ????
     
  2. ernie

    ernie Two Time F1 World Champ
    Lifetime Rossa Owner

    Nov 19, 2001
    22,620
    The Brickyard
    Full Name:
    The Bad Guy
    I don't see why not.
     
  3. smile550

    smile550 Rookie

    Sep 5, 2005
    10
    Northern California
    did you ever get it resolved?
     
  4. thibaut

    thibaut Formula Junior

    Feb 28, 2004
    530
    London, UK
    Full Name:
    Thibaut A.
    nope comes up from time to time. checked quickly the wires not in the way.... been to busy at work recently to worry about that
     
  5. f355spider

    f355spider F1 World Champ
    Owner Rossa Subscribed

    May 29, 2001
    18,055
    USA
    Though the dealer should have already done this, I would recommend removing and reseating the shock accuators again. I would also clean the connectors with some electrical contact cleaner and treat them with a electrical contact enhancer like Stabilant 22.

    I was getting an occaisional suspension light on my 355, and this procedure corrected it for me.
     
  6. ferrarifixer

    ferrarifixer F1 Veteran
    BANNED

    Jul 22, 2003
    8,520
    Melbourne
    Full Name:
    Phil Hughes
    Fchatter stephens 550 had a recurring light too. Turned out to be a dislodged pin in the chassis loom connector block.

    Also, fiddling with the car without driving it ie turning ign on and off loads of times, will set the light off. Just drive it a while.
     

Share This Page