As I'm sure that, IIRC, it should read incorporeal. Well, that's what I was taught in property law, anyhow!
Hey PP,ive been down the hole for the last 4 days,so i havent chased it up yet. Phil sent it tuesday,express,so i assume its here. Im on days off now,so i have all weekend to play with it. Ill go and pick it up tomorrow and do it tomorrow! tee hehehe
Thanks Phil,i just went and picked the 2nd lot of clutch plates just then. I took some measurements a minute ago,from the 1st plates and these. There is nothing in it mate. After the initial f*ck up at 28.5mm,when we took it to 30mm,then 8 thou extra and chamfered edges. It seems that maybe a little more shaven off,maybe another 4 thou would have done the trick? Whos knows. I know that it was very irritating but. Your legend mate was close,but not close enough I was goin to fit these bad boys today,but i remembered about a work mates goin away lunch/piss up at the local watering hole,so im goin there at 12pm. Ill do the clutch tomorrow,maybe post pics if im not running out of free pic posting "bar" hehe. Thanks again Phil,your a champ!
I seem to have unlimited picture loading, so just email them to me and I'll put them on... I havent even seen your new ones myself!! Good luck, and enjoy....
Well well well,how conveinient! Cool man,well, ill take a pic right now! I just got home from the local! Phil,email me your address,so that i can send the others back,i couldnt read it on the parcel that was sent man! Seemed like a 5 year old wrote on it
Here you go lads. The new one is on the left. Smaller centre hub spline. But the same specs. Old one is being sent back to Phil to use as a paper weight Same ****! I havent checked to see if it fits yet. But ive got Phil's 100% guarantee that it will! Image Unavailable, Please Login
more fixings holding the spline to the plate on the old one. will that make any difference FF? (not trying to cause trouble here)
