Coolant Leak on F355 | FerrariChat

Coolant Leak on F355

Discussion in 'Technical Q&A' started by 355Aussie, Nov 2, 2007.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.

  1. 355Aussie

    355Aussie Formula Junior

    Joined:
    Jul 3, 2007
    Messages:
    688
    Location:
    Sydney
    Full Name:
    George
    Well here we go again. Did the engine out service 3 months ago. Replaced all hoses and did the water pump.

    There is still a small coolant leak occurring. Initially I remembered that I forgot to tighten the heat exhchanger gasket so I did this.

    But still coolant leaking from somewhere. When you look everywhere in the car you can only see it around the heat exhanger area and not water pump.

    I have had the car on the track 3 times since the engine out service and no major issues with temperature or big coolant leaks coming out.

    Just a very slight leak occurring and not always to.

    Can anyone let me know what else I can do to find where it is coming from??
     
  2. PAP 348

    PAP 348 Ten Time F1 World Champ Lifetime Rossa Owner

    Joined:
    Dec 10, 2005
    Messages:
    100,234
    Location:
    Mount Isa, Australia
    Full Name:
    Pap
    Perhaps get the cooling system pressurized with a tester to check for the leak mate. :):)
     
  3. 355Aussie

    355Aussie Formula Junior

    Joined:
    Jul 3, 2007
    Messages:
    688
    Location:
    Sydney
    Full Name:
    George
    I have done that but it does not show clearly where it is coming from.

    It is one of those mysteries!!
     
  4. carlrose

    carlrose Formula Junior

    Joined:
    Nov 25, 2003
    Messages:
    327
    Hi,

    If you're really puzzled one can purchase a bottle of fluorescent cooling system dye, pour into system, run the car, and then inspect with a black light.

    Best,

    Carl
     
  5. ernie

    ernie Two Time F1 World Champ Lifetime Rossa Owner

    Joined:
    Nov 19, 2001
    Messages:
    22,620
    Location:
    The Brickyard
    Full Name:
    The Bad Guy
    Have you had a look at the hose in between the throttle bodies/intakes? It feeds the crossover to the heads. That can be over looked sometimes. Also have a look at the thermostat hosing, it's only held down with three nuts.
     

Share This Page