Mondial Temp/Pressure sensor thread/pitch | FerrariChat
Buy

Mondial Temp/Pressure sensor thread/pitch

Discussion in 'Technical Q&A' started by racespecferrari, Dec 12, 2007.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.

  1. racespecferrari

    racespecferrari F1 Veteran

    Jan 31, 2006
    7,583
    Suffolk, Uk
    Full Name:
    Pete.G By The Sea
    #1 racespecferrari, Dec 12, 2007
    I did a search and couldn't find what I needed to know.

    I have just purchased a Pi System 2 dash and I am now sorting out the various sensors.

    Can I just use the original sensors and just fit them on the loom of the new dash I have got?

    What are the threads on the Mondials Oil Temp & Pressure sensors, and also the water temp sensor?.

    Finally, what psi/bar do they run at.

    Any help would be appreciated, Pete
     
  2. luckydynes

    luckydynes F1 Rookie

    Jan 25, 2004
    3,931
    CA and OR
    Full Name:
    pit bull
    #2 luckydynes, Dec 12, 2007
    The oil pressure sending unit thread below the filter is a "standard" metric pressure fitting for which you can buy an adapter if stock sending unit isn't compatible with new system . .. .wondered if I'd have to swap all sending units with one of these systems.
     
  3. racespecferrari

    racespecferrari F1 Veteran

    Jan 31, 2006
    7,583
    Suffolk, Uk
    Full Name:
    Pete.G By The Sea
    #3 racespecferrari, Dec 12, 2007
    Thanks Sean.

    I would prefer to use the original sensors if I could, as in the manual its states about having them fitted to a pipe rather than straight into the engine to avoid vibration & failure.
     

Share This Page