Cannot engage 1st gear - 308 QV - Help ! | FerrariChat

Cannot engage 1st gear - 308 QV - Help !

Discussion in '308/328' started by wowow, Sep 19, 2008.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.

  1. wowow

    wowow Karting

    Jan 21, 2008
    75
    When I shift into 1st gear, the lever went into the slot, but when I release the clutch, no gear is engaged, ie the car did not move and rev did not drop. I then add a little gas, its just like being in neutral. I tried shifting into 2nd , then back on 1st, and its still the same. Only when I shift into reverse, then into 1st, and works. Has anyone experienced this before ?
     
  2. Wade

    Wade Three Time F1 World Champ
    Owner

    Mar 31, 2006
    32,793
    East Central, FL
    Full Name:
    Wade O.
    Might need a little more info; problem came out of the blue? Recent trans/clutch work? Just bought the car?

    Based only on what you've written here I'd check the linkage for some adjustment first.
     
  3. wowow

    wowow Karting

    Jan 21, 2008
    75
    The cra has been working fine and the problem just came "out of the blue". Once shifting into reverse then to 1st, everything just work normally.... until the car stops and goes directly into first again, then the problem reappears.
     
  4. M.James

    M.James F1 Rookie

    Jun 6, 2003
    2,721
    Worcester, MA
    Full Name:
    Michael.C.James
    Sounds like a shifter fork is out-of-alignment. Not a big task at all.
     
  5. ClydeM

    ClydeM F1 World Champ
    Owner Rossa Subscribed

    Nov 4, 2003
    12,094
    Wayne, NJ
    Full Name:
    Clyde E. McMurdy
    Do a search on not going into first.
    There's *lots* of threads on it.

    Usually, as was my case, one of two linkage bushings goes bad from age. If those were recently replaced, then look at the alignment.
     
  6. wowow

    wowow Karting

    Jan 21, 2008
    75
    Thanks a lot
     

Share This Page