Hi, I have a 2000 360 f1, codes read P1617, P1619 , It has the ASR and ABS light on. Car runs fine an thoughts would be great. Thanks Anthony
I don't recognise the codes I'm afraid. You might try a re-set of systems by cutting the battery power overnight and running through a start-up routine next day. Might just cure the issue? Was there anything else going on at the time the problem surfaced?
ABS sensor issue probably. Could simply be a bad connection. Was there recently any work done on the suspension or has it recently been driven in the rain?
Battery was dead and replaced with new one, car seems to run fine, I have reset with OBD scanner and it comes right back. I will check the Sensor wires.
I had a similar problem. Once you reset with the OBD II cut the power using the knob in the front trunk for 20 min. You then go through a drive cycle,
Anthony, Here are the details of your error codes : P1617 : ROADBED SENSOR - A malfunction of the accelerometer sensor for roadbed or probable S.C. has been detected to Vbatt - VALUE TOO HIGH - Wiring/component intactness check P1619 : ROADBED SENSOR - High value read on the roadbet sensor input. Possible S.C. to +VBatt - VBATT SHORT CIRCUIT- Wiring/component intactness check These errors are managed by the Motronic ME7 ECU's. It looks like you've a wiring issue
Sounds like accelleration sensors in front or rear of car. SD2 can tell you which one went baaad. Might remotely be the ABS pump/control unit...
