355 CV Inner Boot Replacement | FerrariChat
Buy

355 CV Inner Boot Replacement

Discussion in '348/355' started by mpodgor, Oct 7, 2011.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.

  1. mpodgor

    mpodgor Formula Junior

    Aug 15, 2005
    661
    San Mateo, Ca.
    Full Name:
    Michael J Podgorski
    #1 mpodgor, Oct 7, 2011
    Last edited by a moderator: Sep 7, 2017
    When I did my cats I found my RH inner boot destroyed. I have the parts. I did the search thing but am still unclear as to how to replace that sucker. One post said something about the Cat having to come out. The outer boot looks OK. So if I could get some advice on the R&R of the boot I would be grateful!!
    Image Unavailable, Please Login
    Image Unavailable, Please Login
    Image Unavailable, Please Login
    Image Unavailable, Please Login
    Image Unavailable, Please Login
    Image Unavailable, Please Login
     
  2. Rob'Z

    Rob'Z Formula 3

    Mar 29, 2008
    1,024
    Tucson,AZ
    Full Name:
    Robert
    #2 Rob'Z, Oct 7, 2011
    I was able to R&R my passenger inner without removing any exhaust components. I will admit it took quite some time to wiggle it free but it came. Going back together was easier them removing, go figure.

    There is a clip that holds everything together, don't let it fly off and get lost (unless you have a replacement at hand). Other than that it's pretty straight forward.


    Rob
     
  3. mpodgor

    mpodgor Formula Junior

    Aug 15, 2005
    661
    San Mateo, Ca.
    Full Name:
    Michael J Podgorski
    #3 mpodgor, Oct 7, 2011
    Well that's good news. So tell me if I'm the right track. I remove all the bolts around the cv joint. Does the clip keep the axle in the tranny? I assume the axle is splinned into the tranny? I was going to get dirty but I ran out of daylight. My little garage is too damn small.Just a poor guy with a Ferrari.
     
  4. shado

    shado Guest

    May 5, 2011
    267
    London
    Full Name:
    Shado Ra
    #4 shado, Oct 8, 2011
    Last edited: Oct 8, 2011
    If you need a step by step how to. Drop me a pm and i will give you a link which is on another ferrari forum.
     
  5. mpodgor

    mpodgor Formula Junior

    Aug 15, 2005
    661
    San Mateo, Ca.
    Full Name:
    Michael J Podgorski
    #5 mpodgor, Oct 8, 2011
    PM in a few.
     
  6. Rob'Z

    Rob'Z Formula 3

    Mar 29, 2008
    1,024
    Tucson,AZ
    Full Name:
    Robert
    #6 Rob'Z, Oct 8, 2011
    The clip holds the CV on the axle shaft. You need to remove it so you replace the boot.


    The 6 bolts hold the cv to the gearbox output, no splines or clips.
     

Share This Page