Rocking seats | Page 3 | FerrariChat

Rocking seats

Discussion in '348/355' started by Houston348, Oct 8, 2007.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.

Page 3 of 3
  1. modena2904

    modena2904 Formula Junior Owner

    Joined:
    Jul 6, 2007
    Messages:
    917
    Location:
    Ellicott City, MD
    Full Name:
    Eric
    Sorry I never saw this when you first posted the question...

    I took a standard L-shaped allen wrench and used a dremel cut-off wheel to make the short side really short. I cut it basically just at the point where the curve ends (if that makes any sense). I was able to get it seated into the screw head and get enough of a swing to tighten it up.

    I also locktited the heck out of all of the screws. So far they are holding...

    - Eric
     
    modena2904, Oct 2, 2012
    #51
  2. ClydeM

    ClydeM F1 World Champ Owner Rossa Subscribed

    Joined:
    Nov 4, 2003
    Messages:
    12,094
    Location:
    Wayne, NJ
    Full Name:
    Clyde E. McMurdy
    I did the same mod to the key. But I couldn't get one deep-set screw very tight, but it was snug. So I'll be examining the gear-lock next.
     
    ClydeM, Oct 2, 2012
    #52
  3. jerhofer

    jerhofer Formula Junior

    Joined:
    Jul 10, 2013
    Messages:
    291
    Location:
    Rockwell, NC
    Full Name:
    Jerry Forthofer
    jerhofer, Sep 15, 2014
    #53
  4. Shaide

    Shaide Formula Junior Silver Subscribed

    Joined:
    Jul 8, 2008
    Messages:
    613
    Location:
    Las Colinas, DFW TX
    Full Name:
    Jason
    Shaide, Sep 15, 2014
    #54
Page 3 of 3

Share This Page