As we told in the beggining , there are some updates to be done to this car. One of those is the HVAC panel cover . I know that this procedura has been shown here lots of times , so sorry to do it again So , first thing to do is take the HVAC out of the centre console Image Unavailable, Please Login Image Unavailable, Please Login Image Unavailable, Please Login
The HVAC panel has 4 screws at the back that you need to take out... Image Unavailable, Please Login Image Unavailable, Please Login Image Unavailable, Please Login
Gently separate the front from the white plastic back cover Image Unavailable, Please Login Image Unavailable, Please Login
I decided just to take out the 2 small buttons , since each was in the wrong place Image Unavailable, Please Login Image Unavailable, Please Login Image Unavailable, Please Login
Now it´s time to deal with the front of the panel. Start peeling off the damaged bubbly cover ... Image Unavailable, Please Login Image Unavailable, Please Login
Now you have to clean it So take your time and take all the old glue out until it looks like this Image Unavailable, Please Login
After all the cleaning you apply the new cover . Try to get the best position for the knobs Image Unavailable, Please Login
Put back the 2 small buttons . The 4 screws back to place ... and You got it!!! Image Unavailable, Please Login Image Unavailable, Please Login
Hello Back to the mechanical bits One of the rear shock absorber was leaking so both went to be repaired Image Unavailable, Please Login Image Unavailable, Please Login Image Unavailable, Please Login
Cam cover were taken to be painted and also so that we could change all the oil seals Image Unavailable, Please Login Image Unavailable, Please Login
The cam seals were changed... Image Unavailable, Please Login Image Unavailable, Please Login Image Unavailable, Please Login
Time for some photos of the work done on the 355 Pulley back in place... Image Unavailable, Please Login Image Unavailable, Please Login Image Unavailable, Please Login
Both bearings in place New belts also in place Image Unavailable, Please Login Image Unavailable, Please Login Image Unavailable, Please Login
Good job for not breaking the green lights!! Keep up the good work. Sent from my iPhone using Tapatalk
Sorry for taking so long to post new photos!! Back to the engine... New belts in place and starting to put everything in place for the degreeing Image Unavailable, Please Login Image Unavailable, Please Login
Meanwhile the radiators were ready to go back into place . Image Unavailable, Please Login Image Unavailable, Please Login Image Unavailable, Please Login
It's hard to tell from your photo but your indicator probe looks to be on a bit of an off angle. Be sure it's co-linear to the travel axis of the lifter. I use this probe tip to be sure I can accomplish that Image Unavailable, Please Login
Thank you ! These photos were taken when we installed the tools on the engine . we then put it as it should , in line with the travel axis of the lift
Hello! Radiators back in place !! Image Unavailable, Please Login Image Unavailable, Please Login Image Unavailable, Please Login