355 rear transaxle mounts | FerrariChat
Buy

355 rear transaxle mounts

Discussion in '348/355' started by hjp, Jul 1, 2016.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.

  1. hjp

    hjp Formula Junior

    Feb 23, 2013
    591
    Kansas City, Mo.
    Full Name:
    Jerry Peterson
    #1 hjp, Jul 1, 2016
    I'm about to replace the rear mounts on my 355. The car is on jack stands. I plan to jack the motor just enough to take the load off the mounts (1/16" or so). Since there is a "cone" under the bracket that fits down inside the mount, it looks to me like the 2 brackets need to come off to get enough clearance to get the old mounts off.

    I don't want to jack the engine high enough to get the clearance for fear of stressing "stuff" connected at the front of the engine.

    So, for those who have done this, am I correct, do the 2 brackets need to come off?
     
  2. FCOnyx

    FCOnyx Formula Junior
    Owner

    May 28, 2012
    413
    Round Rock, TX
    Full Name:
    Jeff
    #2 FCOnyx, Jul 1, 2016
    Yes.
     
  3. WATSON

    WATSON Two Time F1 World Champ
    Owner Rossa Subscribed

    Sep 9, 2010
    23,941
    WI
    #3 WATSON, Jul 1, 2016
    ^^^^ what he said ^^^^
     
  4. yelcab

    yelcab F1 World Champ
    Consultant

    Nov 29, 2001
    13,674
    San Carlos, CA
    Full Name:
    Mitchell Le
    #4 yelcab, Jul 1, 2016
    And you need more than 1/16th of an inch,
     
  5. hjp

    hjp Formula Junior

    Feb 23, 2013
    591
    Kansas City, Mo.
    Full Name:
    Jerry Peterson
    #5 hjp, Jul 1, 2016
    You're probably right. I need to jack it enough to release the pressure on the brackets which will be however much the mount rubber has been compressed from the load plus a little for insurance. Then remove the 2 brackets and the old mounts.

    yelcab, what has been your experience, 1/8" or so? I guess I'll find out but just curious.
     
  6. yelcab

    yelcab F1 World Champ
    Consultant

    Nov 29, 2001
    13,674
    San Carlos, CA
    Full Name:
    Mitchell Le
    #6 yelcab, Jul 1, 2016
    Remove all nuts and bolts having to do with the mount and brackets. Raise the engine by 1/2 inch, slide the bracket down and out. Then the engine mount goes up and out.
     
  7. Dave rocks

    Dave rocks F1 World Champ
    BANNED

    Nov 23, 2012
    16,047
    Orchard Park, NY
    Full Name:
    Dave Lelonek
    #7 Dave rocks, Jul 1, 2016
    Mitch, can you be a bit more specific as Jerry is looking to only do trans mounts. What is the "bracket" ?

    Thanks
     
  8. yelcab

    yelcab F1 World Champ
    Consultant

    Nov 29, 2001
    13,674
    San Carlos, CA
    Full Name:
    Mitchell Le
    #8 yelcab, Jul 1, 2016
    Sorry about that man. The rear mounts are a bit easier, but you still need to jack it up more than 1/16 inch.
     

Share This Page