360 Steering Column Plastic Clam Shell Removal- | FerrariChat
Buy

360 Steering Column Plastic Clam Shell Removal-

Discussion in 'Technical Q&A' started by sparetireless, Jun 9, 2018.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.

  1. sparetireless

    sparetireless Formula 3

    Nov 2, 2003
    1,596
    #1 sparetireless, Jun 9, 2018
    Does the lower leather trim have to come off first or can it be done without all that effort?
     
  2. Bob in Makiki

    Bob in Makiki Formula Junior
    Owner

    May 30, 2017
    455
    Honolulu
    #2 Bob in Makiki, Jun 9, 2018
    You might check the threads in the 360 forum dealing with tach face replacement. They are quite detailed and have photos. If I am not mistaken, this is a step in that process, so those threads may help. Or maybe not! It has been a while since I looked at them. Good luck!
     
  3. Mickster

    Mickster Formula Junior

    Oct 24, 2015
    608
    Sweden
    Full Name:
    Mikael Andersson
    #3 Mickster, Jun 11, 2018
    Yup! Check out ”sticky section” tech threads on 360/430 forum. Tach face removal thread will help you a lot. Lots of pics.
     
    Bob in Makiki likes this.
  4. Sled Driver

    Sled Driver Formula Junior

    May 13, 2010
    494
    Stokesdale, NC
    Full Name:
    Emery
    #4 Sled Driver, Jun 12, 2018
    You do not need to remove the lower half of the dash to remove the steering column cover. There are four screws on the bottom in recessed holes & a fifth screw on a tab under the dash. By telescoping & adjusting the "tilt" angle of the column you can access & remove all the screws. From there carefully separate the two halves to remove it.
     
    killer58 likes this.

Share This Page