Gearbox problem after new clutch 360 Modena 2001 | FerrariChat

Gearbox problem after new clutch 360 Modena 2001

Discussion in '360/430' started by SwedenPeter, Oct 11, 2018.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.

  1. SwedenPeter

    SwedenPeter Rookie

    May 9, 2013
    18
    Sweden
    Full Name:
    Peter Dahlstrom
  2. radlu

    radlu Formula Junior

    Jun 6, 2005
    407
    I would just drive it for a couple weeks. Likely the clutch just needs to be broken in.
     
  3. 24000rpm

    24000rpm F1 Rookie

    does the car drive ok?
    if not, as an internet mechanic and internet ferrari expert (tongue in cheek), i'd suppose those 2x sensor cables were installed incorrectly?

    why do you want to disconnect the ground point if its only a clutch job?

    those ground harness are usually only touched when you are pulling the engine or replacing the harness




     
  4. SwedenPeter

    SwedenPeter Rookie

    May 9, 2013
    18
    Sweden
    Full Name:
    Peter Dahlstrom
    I didnt disconnect the ground it was like that !! The sensor cables is installed correct. The car was alive for about 150 km then the problem starts
     
  5. radlu

    radlu Formula Junior

    Jun 6, 2005
    407
    What about doing several hard launches off the line to break in the clutch?
     
  6. 24000rpm

    24000rpm F1 Rookie

    ok, get me thinking: more of a installation problem than an actual problem

     

Share This Page