360 water pump and thermo change | FerrariChat

360 water pump and thermo change

Discussion in 'Technical Q&A' started by 78bonanza, Nov 30, 2019.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.

  1. 78bonanza

    78bonanza Formula Junior

    Apr 1, 2018
    331
    Full Name:
    Jim Cear
    #1 78bonanza, Nov 30, 2019
    Going to change the water pump and thermostat on my 360 . I have the shop manual . Ordered parts,gaskets,clamps, etc from Ricambi.
    Any other hints, tips or advise on the change ?
     
  2. tazandjan

    tazandjan Three Time F1 World Champ
    Lifetime Rossa Owner

    Jul 19, 2008
    38,072
    Clarksville, Tennessee
    Full Name:
    Terry H Phillips
    #2 tazandjan, Nov 30, 2019
    Likely more advice available in the 360/430 forum, if it has not already been covered.
     
  3. Rifledriver

    Rifledriver Three Time F1 World Champ

    Apr 29, 2004
    34,068
    Austin TX
    Full Name:
    Brian Crall
    #3 Rifledriver, Dec 1, 2019
    If you do not use an Airlift the 360 is notoriously hard to bleed.
     
    2NA likes this.
  4. vincep99

    vincep99 Formula 3
    Owner Silver Subscribed

    Jun 8, 2009
    1,930
    #4 vincep99, Dec 3, 2019
    Agreed, look on the 360 section.

    Rifledriver is right (as always) about bleeding. You can;t even see the bleed screw. I used a goose-neck inspection scope so I could locate it and loosen it. Still a PIA
     
  5. yelcab

    yelcab F1 World Champ
    Consultant

    Nov 29, 2001
    12,662
    San Carlos, CA
    Full Name:
    Mitchell Le
    #5 yelcab, Dec 3, 2019
    Use an Airlift.
     
    2NA likes this.
  6. 78bonanza

    78bonanza Formula Junior

    Apr 1, 2018
    331
    Full Name:
    Jim Cear
    #6 78bonanza, Dec 3, 2019
    Ordered , on its way
     

Share This Page