Purchased this WP from a well known vendor in NJ, USA. I am hesitant to install it due to these craters, voids in the casting. What do you think? Image Unavailable, Please Login
I think some good gasket adhesive/sealer and you’re good. Too bad they’re using poor cores but there are only so many good cores out there.
At some time it whas also dropped to the floor. See mark on the lowest part on that picture. I would think you have reason enough to complain. Guido
That can be easily repaired via cold-spray technology. But it should have been done during the manufacturing/re-manufacturing process, not by the customer. https://www.supersonicspray.com/ Sorry, but your pump shouldn't have passed quality-control. And no way would I use anything like that on a 3.4 motor (which I see you don't have).