Air intake | FerrariChat

Air intake

Discussion in 'Mondial' started by DocBasilone, Jul 6, 2020.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.

  1. DocBasilone

    DocBasilone Karting

    Apr 15, 2020
    164
    NW PA
    #1 DocBasilone, Jul 6, 2020
    On the 90 cabriolet is there supposed to be a clamp around the Air intake where it attaches to the body. Mine is easily dislodged and I found it partially off after a drive today. Will that make the idle rough as well?


    Sent from my iPad using FerrariChat
     
  2. spicedriver

    spicedriver F1 Rookie

    Feb 1, 2011
    3,859
    #2 spicedriver, Jul 6, 2020
    I thought there were screws holding it in. Either way, it shouldn't affect the mixture.
     
  3. DocBasilone

    DocBasilone Karting

    Apr 15, 2020
    164
    NW PA
    #3 DocBasilone, Jul 7, 2020
    I’m wondering if they took it off to get my furl tank out and never replaced gasket or screw. Manual doesn’t show screws but shows gasket for coupe. Also found leak under power steering oil reservoir I think one hose is also loose and dripping on manifold. Smoking on start up


    Sent from my iPad using FerrariChat
     
  4. Wingnut

    Wingnut Karting

    Feb 11, 2005
    126
    Corolla, NC
    #4 Wingnut, Jul 7, 2020
    My 1990 Cabrio has a rubber ring around each end of the big air intake tube, just a press fit, no screws. Your rubber ring may have cracked or hardened after 30 years of engine heat, creating a loose fit. A dryer vent clamp would secure it. Painted black.
     
    DocBasilone likes this.

Share This Page