Hours of cleaning and re-coating
Thanks mate, I appreciate any help you can give, I am based in Oz so, less complicated if we just make a drawing and I have all the tooling in my workshop. Thanks again, and good luck with the project.
Used a high gloss clear on the control arms stop corrosion and makes it easier to clean later on next steering hub.
Image Unavailable, Please Login Image Unavailable, Please Login Image Unavailable, Please Login Image Unavailable, Please Login Image Unavailable, Please Login
Image Unavailable, Please Login Image Unavailable, Please Login Image Unavailable, Please Login Image Unavailable, Please Login Image Unavailable, Please Login
replaced shock bushing and front anti roll bar bushings , replacing all the left hand front corner with Ti fasteners should be here Monday . Ti fasteners for the carbon fiber door panels thinking theses will really look Bad Ass can not wait to see them installed !!
First pic stock CS carbon fiber fastener, new Ti large hex head flanged with holes . Image Unavailable, Please Login Image Unavailable, Please Login Image Unavailable, Please Login Image Unavailable, Please Login
There's sixteen 4mm thick by 25mm OSD washers spacers for the upper control arms front and back replacing with Ti . The large flange hex head with holes are only made in 6mm . I want to use these for engine bay carbon fiber panels but you need 5mm ones . You can have some custom made it would very expensive unless order in a big bulk like couple hundred at a time bring the cost down maybe 7.00 a piece .
Image Unavailable, Please Login Image Unavailable, Please Login Image Unavailable, Please Login Image Unavailable, Please Login Image Unavailable, Please Login
First pic is original bumper US DOT approved second my new CS Euro style rear bumper around 20 pounds lighter !!
blocks out all that sand and gravel , wend I removed old side skirts it was full of sand and gravel...