We're new to the F cars and need a couple minor parts that our missing on our 360 Spider. 1. Rubber vibration damper for the rear bonnet... Image Unavailable, Please Login I found it on the parts diagram, can you plz confirm? It's #053 here.... https://ferrparts.com/diagrams/360-spider/shields-outside-finishing-141#053 2. Some type of cap in the interior, driver's side. Unable to find it in the diagrams. Image Unavailable, Please Login Any/all help appreciated. Thanks
The missing rubber plug in your carpet is this: https://www.ricambiamerica.com/14507987-plug.html I blame this one on Hendricks Gin and Fever Tree tonic.... but I can't tell from your picture of the rear hatch which rubber is missing. Do you mean this one? https://www.ricambiamerica.com/62167600-pin.html. (#23 in attached diagram) Image Unavailable, Please Login
these are pad's and not available from my research - not even used. I have a 360 spider that had one pad. I worked with a friend and reengineered them using a 3d printer and a polymer plastic - they fit perfect Below are pictures of them. The one on the right was the original part. Image Unavailable, Please Login Image Unavailable, Please Login Image Unavailable, Please Login
Yes that is the part number @Ricambi America your site listed them and unavailable. This is why I set out to recreate them. I even tried several salvage yards these are hard to come by once they are gone. The original has a metal base encased in some type of rubber or plastic the top is very hard rubber - the ones we created are of hard polymer. I have installed them on my 360 and they seem to work as the original. let me know if there is any interest in these parts.
Hey Neil...our 360 only has one as well, the rear hatch sits a little low at that area so thinking the damper would raise it up a little when closed.. Heres the one on the drivers side... Image Unavailable, Please Login I may be interested in buying two...please PM me with cost with shipping to Texas. Thanks
Ok, you guys are good, need one more part while I am at it. The hardware that holds the floor mat in place... Image Unavailable, Please Login I've seen the klaw but prefer the original. Thanks
If the clamshell is low there is an adjustment on the hing. Stop the top half way with the clamshell open. You will need to prop the clamshell open. You will need Alan keys I had to add a shim under the bolts to get the clamshells to be level with the body I was out of adjustment. Be careful about any adjustments it can and in my case did affect the micro switches when I tried adding a shim to the back where it attaches to the body and the top stopped going down!! Shimming the cover did not stop the top working correctly The pads are used to stop any vibration of the clamshell Since you are new to the 360 I would suggest getting an Autel AP 200 this will read all the codes in the car including the convertible top computer I will pm a cost to you for the pads Sent from my iPhone using FerrariChat
Those look like pieces of a hockey puck after it was attacked for 5 minutes with a hacksaw, drill and sandpaper. I'd make them that way if I needed them.
Hey Neil...the clamshell is fine, it's the back hatch that is low [on the right side where there is no damper]. Thanks for your help
Hey @Stev-o - there is an adjustment under the clamshell where the pad goes it will move the clamshell up or down its where the hinge bolts to the clamshell open the top and stop it once the clamshell is open you will see the 2 Alan screws where the hinge is adjustable
Neil22 - Yes, yours look great! However, I don't have either the equipment or the skillset to make them with a 3D printer so I'd be forced to make them by hand.