Hi Mike, Just wanted to check with you, is there any special way that I will need to press the inner sleeve back into the outer bushing. I finally have everything back from plating. Russ
Putting it back is actually easier, I just used my vise to press the sleeves in until the sleeve is flush on both sides. View attachment 3094306
Hi Mike, Thank you, I wasn't sure if I needed any outside support on the sleeve when pressing it back into the outer bushing. I used my press, since my vise isn't a very good.
I would like to know if anyone encountered a problem with the inner sleeve being too tight for inserting the inner bushing. I was only able to insert 4 inner bushings into the inner sleeve. The other 4 I couldn't by hand. I suspect that they do not need to be forced into the inner sleeve.