348 top shock nut? | FerrariChat
Buy

348 top shock nut?

Discussion in 'Technical Q&A' started by Ferrarium, Jan 12, 2022.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.

  1. Ferrarium

    Ferrarium F1 Veteran
    Sponsor Rossa Subscribed

    Jul 28, 2018
    5,728
    Central NJ
    Full Name:
    Eric
    #1 Ferrarium, Jan 12, 2022
    Anything special to note or technique to be aware of for removing the shock top nut? It looks like the shaft has a slot in it to hold it still while turning the nut.

    Image Unavailable, Please Login
     
  2. Ferrari Tech

    Ferrari Tech Formula 3

    Mar 5, 2010
    1,233
    Georgia
    Full Name:
    Wade Williams
    #2 Ferrari Tech, Jan 13, 2022
    It is under tremendous pressure from the spring. It MUST be in a spring compressor. I usually use an impact to break it loose. Make sure it is all clocked properly when you tighten it.
     
    2NA likes this.
  3. Ferrarium

    Ferrarium F1 Veteran
    Sponsor Rossa Subscribed

    Jul 28, 2018
    5,728
    Central NJ
    Full Name:
    Eric
    #3 Ferrarium, Jan 13, 2022
    Right, the springs are off the shock. I imagine the shaft the nut is on will spin unless held, presumably with that slot in the shaft.

    Sent using FerrariChat.com mobile app
     
  4. fatbillybob

    fatbillybob Two Time F1 World Champ
    Consultant Owner

    Aug 10, 2002
    29,272
    socal
    #4 fatbillybob, Jan 13, 2022
    Correct. If the springs are off it is probably not much more than hand tight. Often the friction within the shaft to shock will be enough such that your impact gun can spin the nut off without having to "fix" the shaft. Be careful around springs. There is a lot of energy in there. If you are not familiar with this look, study, move slowly. "Measure twice cut once."
     
  5. Ferrarium

    Ferrarium F1 Veteran
    Sponsor Rossa Subscribed

    Jul 28, 2018
    5,728
    Central NJ
    Full Name:
    Eric
    #5 Ferrarium, Jan 13, 2022
    Actually replacing control arm bushings and powerboating the arms so I had to compress spring to get them out, I then removed removed the springs once off and bought new springs to put in. I'll replace those pillow blocks as well. Thanks!
     
  6. Ferrarium

    Ferrarium F1 Veteran
    Sponsor Rossa Subscribed

    Jul 28, 2018
    5,728
    Central NJ
    Full Name:
    Eric
    #6 Ferrarium, Jan 13, 2022
    Yep spun right off FBB, reinstalled with no springs to clock it and light hit with impact wrench. Easy peasy. Thanks !

    Sent using FerrariChat.com mobile app
     

Share This Page