430 Ferrari F430 O2 Sensor and Evap Sensor Not Ready

Hi guys,

Just got my car back from service about a week ago. Put around 200 miles on it on maybe 3 drives.

Went to get inspected in Texas and it failed as the O2 and Evap sensors weren’t ready.

No check engine lights at all. Scanned in my Autel AP200 and confirmed. There seems to be two Oxygen sensors and both were INC - as I recall.

Drove another 100-130 miles. Now one of the sensors, $7E8 Oxygen Sensor shows OK, but the $7EA Oxygen sensor shows it is still not ready. I’ve followed various drive cycles on the site.

Car has Fabspeed Headers, but is stock besides that. Is that the cause?

Any solution to this issue?
Any help is appreciated! Thanks!

 

Also, I’m assuming both Oxygen sensors have to be ready for it to pass? I know in Texas, we can have one sensor not be ready.

 

As far as my knowledge, car is stock. It has all the papers with the car with everything, so I assume it’s not. PPI/Mechanic/Paperwork just shows aftermarket Fabspeed Headers. Is there anyway to check if it is tuned?

It’s a 2008 Coupe also.

 

Just want to update for the community:
Evap sensor turned on (o2 never turned on)

I guess car just needed more drive time. Drove roughly 400 miles and 12-15 startups. Tried to follow all the drive cycles listed online, no success.

Went to get coffee in it with no attempt at a drive cycle, came back and checked it and it worked. Guess it just needed to be driven more? Odd, but I’ll take it