New contender for single din carplay

Dang! I missed that some how!

 

On the 360, you have access to the cage retainers if you pull the aluminum surround off. No need to remove the tabs. Through the holes where the window switches are.

 

I bought 2 of these units for my air cooled Porsche's. I thought it was going to look too modern, but it actually blends well. No knobs keeps it fairly clean. Got one hooked up today and I love it. Wireless CarPlay connects easily and sound quality is good. Maps on the screen were easily discernible, I thought the screen would be too small but its good. Happy with the purchase and thanks for the recommendations.

 

I have my first one installed in my Scud and ordered a second for my Maranello. Looks great and works great!

If someone can figure out how to modify the start up screen it would be completely awesome!

 

Just installed mine and took it for a drive. Here is pic of Waze.
Image Unavailable, Please Login

 

Ok this unit has exceeded my expectations. Just went for a drive and it sounds and works great. No problem on the brightness for me.

Image Unavailable, Please Login


Image Unavailable, Please Login

Image Unavailable, Please Login

 

Thanks John! That’s better than I expected. Appreciate your response.

 

Looks very well in the Porker

 

Image Unavailable, Please Login

 

Circling back on the issue I am having (there's also another member who has the same issue), and it appears the issue is the gain setting on the amp (Scuderia Audio). Mike at Scuderia Audio was very helpful and suggested to turn down the gain on the amp that controls the "highs". Did that and the white noise went down to almost unnoticeable. Mike also suggested to use the RCA outs on the head unit and connect to the RCA inputs on the Scuderia Audio amp to further fine tune the sound. I ordered the cables and will try that in a couple of days.

 

I have the same setup (360). RCA from deck to amp. I had to use 90 degree cables at the amp side to fit in the cage. Two foot RCA were a perfect fit.

Used these to come off the amp:

Traovien RCA Audio Cable... https://www.amazon.com/dp/B0BGH3CKYZ?ref=ppx_pop_mob_ap_share

 

I have RCAs from the head unit to my old amplifier. Works fine.

 

I use the RCA inputs on the amp and turning the gain down helped. I’m going to pick up some higher quality cables as well.

 

I go straight from the deck to the amp. Same setup I had with my pioneer fold out unit - which had no noise. Maybe expecting too much for $140

 

What’s the verdict on leaving the GPS antenna unplugged to limit chances of rattles?

Is anyone using the usb cable to charge phones?

 

I didn’t plug the gps antenna in. Left it out.

 

I am using the GPS adapter for the factory GPS antenna which was posted earlier. Seems to pick up satellites very well.

 

To me the parking signal need to attached to 12v to enable viewing videos.
Anyone test ground vs 12v for this?
Image Unavailable, Please Login
Image Unavailable, Please Login

Seems Pink wire is actually a 12V input for reverse signal to trigger rear camera display (input from RCA)
Image Unavailable, Please Login

 

Is the box on the left a parking switch?

Does this look accurate? Why does the brown wire then show 2A fuse if gnd input? Are we supposed to add a fuse?
Image Unavailable, Please Login

 

Can confirm the pink wire is for reverse camera.

 

Thanks for confirming Parking to gnd and pink 12v input for reverse.

 

Just make sure you don’t use the pink front camera wire. I think that outputs power…