For Sale NOVITEC NF-10 FERRARI WHEELS 21/22's

Im interested, but I think duties and shipping would kill any hope of that - you are about as far away from me as you could be and still be on the same continent! Could you PM me and we can give it a shot? I have a set of 20/21 but want the larger profile (I do have tires if shipping just the wheels becomes an option).

 

Any idea if these will fit the 458, Looks like the width is the same. Just unsure of the lug pattern

 

488/f8 wheels wont fit on a 458 - same lug pattern but the 488 has a 1" wider offset in the rear.

 

Here is the measurements that I used:

458 OEM wheel: 10.5j ET58
488/f8 OEM wheel: 11j ET38

If those are correct, it pushes the 488/F8 wheel to the outside fender edge 26mm

 

Correct.. I have seen 488/F8 wheels in stock offset fit....458's fitted with Ferrari OEM 20" stock offset factory wheels....but the rear stock offset for 488/F8 pushes the wheel/tire just slightly outwards barely past the fender. Like running around a 20mm wheel spacer on a 458 OEm wheel. This can be corrected with negative camber or reducing the thickness of the top and bottom shims by equal amount that sets camber.
The tricky part is after market wheels with built in offset that pushes the wheel/tire out more than stock/OEM. I believe wheels like yours and the HRE's I have for sale can fit a 458 but the camber shims for the rear will definitely need to be adjusted and it all depends on what the variation in offset is on the aftermarket wheels being fitted.

I took OEM 458 rear offset and put it in a wheel calculator with my HRE offset...it would be like putting a 43mm spacer on a 458 OEM wheel. I do not believe this wheel will fit a 458.


Best of luck with your sale...great looking wheels you have!

 

Here are the Novitec NF10 rear specs vs 458 OEM.
Image Unavailable, Please Login

 

Don't think this is correct - looks like you are quoting rears, which are 22x12j with an ET33. You might be using your HRE spec'd wheels as the baseline too - which actually gives the same values back! That said, not a chance you can offset 44mm (aka 1 3/4") of a push outer to make them work on a 458.

Funny, there are a lot of wheels advertised as fitting 458, 488, F8. The only way that's possible is if they were build for the 458 first or are OEM spec 488/F8 wheels.

These just aren't available used very often and they tend to sell quickly - GLWS Red Barron!!

 

Oops yore correct…I missed the width… it is 12”. I’d delete/fix my post but this forum for some reason doesn’t allow that.