How do I remove and replace the rear chrome letters? Is it a pop in and out tab? Is it adhesive? Screwed in? I can't find info on this anywhere. My current is fine but it's a littttttle curved on top, probably from someone drying off the car in the past.
See here...clips nr 13 https://www.eurospares.co.uk/Ferrari/Mondial/Mondial_3.0_QV_(1984)/PartDiagrams/113/Bumpers,_Lights_and_Rear_Glasses
OK so will this thing just pop off then if i use a plastic tool? and then the new one will just pop in?
ok and is that done from the in ok and is that done from the inside of the trunk? How do i pop off the black liner on the inside of the trunk lid? Just pop those platic tabs off with force?
yes, pop of those black tabs with a plastic tool. You find the clips there...but be careful. Not easy to remove.
Are there ANY videos online showing how to do this? I can't find anything and the product websites have terrible pictures of these
Those clips look like this Put a small screwdriver under the upstanding arms and try "gently" to lever the clip of.
It is also a very good idea to check that no water can leak from the mounting holes to trunk. After installing the text back, put some paper next to the clips and rinse trunk lid with water. I found large rust damages from my trunk floor, on otherwise rustfree car. I'll see if I have some photos once I have access to my computer.
Here it is BEFORE I straightened it out. Local Ferrari mechanic down the street from me said this is common during car washes... even hand washes Image Unavailable, Please Login
Here is the trunk lid liner remover. Image Unavailable, Please Login You need to disconnect the wire on left corner, and the strut bracket. Good idea to open up the engine lid first. If you open the trunk lid too much, the edge of the engine lid may scratch the trunk lid. On the other photo you can see the tab from Ferrari letters. The clip Guido posted attaches to it. You will find two of them. Image Unavailable, Please Login I put some paper under the letters to test if the letters did still leak. Had to put a bit sealant to get it waterproof.
And so do those black plastic tabs on the liner before getting to this phase just pop out with force? I was thinking of using a butter knige or plastic tool to pop them out. i see the holes for them in your pictures as well from where you had removed them.
Wow! Unbelievable that it could be bent that much, but who takes their Ferrari through an automatic car wash anyway? LOL! If some gorilla did that washing the car by hand, well that's just too much to think about. As far as tools to remove the tabs, you need to get a bunch of these, leave the butter knives in the kitchen. Alden Image Unavailable, Please Login