308 GT4 Dino front lower wishbone removal | FerrariChat
Buy

308 GT4 Dino front lower wishbone removal

Discussion in '308/328' started by miahshodan, Jun 9, 2025.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.

  1. miahshodan

    miahshodan Karting

    Feb 25, 2016
    94
    West Jordan, UT
    #1 miahshodan, Jun 9, 2025
    I have my Dino up on the lift today and I know I need to replace all of the bushings, but as I look at the front lower wishbone, I can't figure out how you would get it off. The nut is on the inside and the bolt is on the outside and it doesn't seem like there is enough room to pull the bolt out. Do you have to cut it off?
    Image Unavailable, Please Login
     
  2. Dockboy

    Dockboy Formula Junior
    Silver Subscribed

    May 11, 2013
    585
    Maryland
    #2 Dockboy, Jun 9, 2025
    You will need to unbolt the fork.
     
  3. GT4andMore

    GT4andMore Karting

    Oct 23, 2020
    66
    Full Name:
    Graham
    #3 GT4andMore, Jun 10, 2025
    All the lower wishbones are on forks which are shimmed to enable the suspension geometry to be adjusted. These are relatively easy to remove as they have a very large and accessible nut on the inside of the chassis. The challenge starts with the upper wishbones. Good luck - keep us posted.
     
  4. miahshodan

    miahshodan Karting

    Feb 25, 2016
    94
    West Jordan, UT
    #4 miahshodan, Jun 18, 2025
    thanks, to get to that nut do you have to remove the under-tray and go from below, or are you going in from on top of the wishbone?
     
  5. GT4andMore

    GT4andMore Karting

    Oct 23, 2020
    66
    Full Name:
    Graham
    #5 GT4andMore, Jun 18, 2025
    You need to remove the undertray and then it will all very straightforward.
     
    miahshodan likes this.

Share This Page