F430 F1 Gearbox Not shifting past 2nd, CAN BUS wiring diagrams.

This is the block plate, them we did a bleed of it and also we bleed the actuators and i changed potenciometer sensors thinking that maybe it was that
Image Unavailable, Please Login

 

did you bleed e-diff

 

Had not bleed it put i tried with a launch and it did not bleed, then i put power to the solenoid and i did bleed it like that, with the sd3 i put ediff bleed and it did got a little of fluid like the line had 0.60 cm filled

 

The most rare thing is that i think when the mechanic put a autel scanner in the car and reset codes or i dont know what and i heard a beep and saw all lights

 

But the guy said that the lights he saw they where already there so not 100% sure

 

At this point ..I am thinking you need to make sure clutch, actuator and E-diff are bled properly
Need to also test E-diff solenoid by activating bleed function (try with engine on and off ) and see if the locking pressure goes up ...also time the pump cycles while you have bleed function activated (without bleed valve open) ..it should be more than a min

 

Thank you Flash 32, how do i see the locking pressure? So when bleed function is ON i should hear the f1 pump going ON automatically every minute? The hydraulic circuit pressure is 51 bar.

 

Use the Sd3 and go into the E-diff ECU
Yes the pump should come on and off

 

Ohhh ok because it does not come On when i give ediff pump on, i put pump on and recieved signal on the ediff sensor but nothing happened early morning.

 

I will try again tomorrow morning, i also find this info in suspension can wire failure
Image Unavailable, Please Login

 

Disconnect E-diff solenoid (not sensor) and see if things change ..still will give error but should be different

 

Yes did that and it did gave me a solenoid code

 

Connect it back and it did clear that code

 

Good morning i tried ediff with sd3 and it does nothing, i tried car of and car on and it did nothing, fluid did not come out just a little bit but f1 pump just activates when car off like 3 min, then when it was ON it never activated

 

0 locking preassure
Image Unavailable, Please Login

 

It Is strange you are not even showing the system pressure on there
Any ideas

 

F1 pump does get to 53 and when making shifts it goes 43, 42, 44 and up to 51 and 53 so that is good, what does ediff makes activate pressure there?
Image Unavailable, Please Login

 

Yes but I don't see it in E-diff ECU

I will send you my number in PM ..call me in a few hours