mondial cab window motor | FerrariChat

mondial cab window motor

Discussion in 'Technical Q&A' started by mikeg, Nov 4, 2003.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.

  1. mikeg

    mikeg Rookie

    Joined:
    Nov 3, 2003
    Messages:
    24
    Does anyone know how difficult a task it is to change a window motor in amondi cab?
     
    mikeg, Nov 4, 2003
    #1
  2. nc_newbie

    nc_newbie Rookie

    Joined:
    Nov 4, 2003
    Messages:
    20
    I did both of mine and it takes about a full day to do both.
     
    nc_newbie, Nov 4, 2003
    #2
  3. mikeg

    mikeg Rookie

    Joined:
    Nov 3, 2003
    Messages:
    24
    Thanks, Is it complicated and does it invlove removing all the lift cables etc?
     
    mikeg, Nov 4, 2003
    #3
  4. jeffQV

    jeffQV F1 Rookie

    Joined:
    Feb 13, 2004
    Messages:
    2,976
    Location:
    NZ
    Full Name:
    jeff
    did mine too, make a drawing before stripping out the old! helps to have a beer or two handy as well!
     
    jeffQV, Jun 18, 2004
    #4
  5. pnorman

    pnorman Rookie

    Joined:
    Dec 30, 2003
    Messages:
    47
    I have a new motor if you need one...Patrick
     
    pnorman, Jun 18, 2004
    #5
  6. TOM B

    TOM B Formula 3

    Joined:
    Jul 24, 2003
    Messages:
    1,038
    Location:
    Orange County, NY
    Full Name:
    Thomas Buckley
    I was about to replace one of my motors when my mechanic told me to try something. When the motor gets stuck-----tap it with a hammer. It worked. I spent some time lubricating the cable , tapping the motor, and working the motor work with the switch. After it was all loose and working consistently, I buttomed up the door. It's worth a try.
     
    TOM B, Jun 19, 2004
    #6
  7. dm_n_stuff

    dm_n_stuff Four Time F1 World Champ Lifetime Rossa Owner

    Joined:
    Dec 10, 2003
    Messages:
    43,889
    Location:
    26.806311,-81.755805
    Full Name:
    Dave M.
    Also, loosen the nuts on the cover for the gears. Do not remove them completely. THen insert a small screwdriver between the plate and spray some WD40 in.

    Run the motor several times up and down, it will loosen the grease, and make the motor run with less drag.

    (I'm assuming the mondial has an arrangement similar to my Dino.)

    It made a big improvement in my car.
     
    dm_n_stuff, Jun 19, 2004
    #7

Share This Page