© 2022 MOTORSPORT NETWORK. All rights reserved.
Get an adaptor.
Has anyone used Prekom ball joint adhesive kemiskol P633 rather than the Hyosol adhesive?
The "Die-Sexing" of your shock is appropriate for the wonky times we now live in. You will have a LGBTQ(it) shock. Up, down, in, out, left. right....
Steelman Chassis Ear is even better if chasing down chassis noises.
In my case, there was very little room under the forward edge of the dash so whatever you use must not be very "deep". And, there is virtually no...
No. The leather is shrinking back away from the front of the dash so it will just carry the Rizzo(or OEM plastic) vent with it. The point of the...
Very little room under the dash. I had to grind the screw flush with the nut to allow the dash to fit properly. McMaster Carr has a blind nut for...
2002. Tether and cap holder bracket.
Mounting screws yes.
Pull out the windshield? You still have to pull out the dash to install the Rizzo metal vents!
ONLY 900 miles on the belts in 8 years is THE reason to do the belt service.
Someone was potty trained way too early.
Clarification about softening copper washers not that it matters since the copper will be dead soft after the heating to cherry red slow cooling...
Generic Goop might eventually break down in gasoline but should last OK with just fuel vapor for awhile. SEAL ALL is the "Goop" that you need...
Sell it as is for $50?
Glue it back in with Goop?
Wha was the reason for his ban?
Correction. The rear of my dash, cockpit side is slightly pulling. Front side secured by Rizzo metal vents is just fine. Why was Rizzo 360 banned?
We talked a bit about this a couple of years ago. I I were you, I would pull the dash myself. There are many, many posts about how to do it and it...
Use a common socket flat head bolt. I had to shorten mine for the dash to fully seat fully. I was able to stretch the original leather back...
