© 2020 MOTORSPORT NETWORK. All rights reserved.
Sign up to receive latest updates for Ferrari News, Threads, and Classifieds
After repair, how do you protect them against water ingress/corrosion?
Intermittent O2 sensor failure?
It's not unusual to have to readjust the handbrake shortly after new pads are fitted. Remember this should be done with a screwdriver through...
Only one pad has a wire to it. Quite similar to this one:...
So bite the bullet and go for it! :)
Can someone please enlighten me on how the wiring for the front brake pad alarms is supposed to be? It has been messed with on my car and I don't...
PM me your mail address and I'll wetransfer you the L-section I have.
Seems like a mechanical failure, after all. Since the hydraulic system is shared with the suspension, which operates at a different pressure, do...
Any feedback on the use of Zerex G-48?
Interesting, neither the 456 nor the 575 have these non-return valves according diagrams from Eurospares. On my 456 there is definitely an open...
Definitely little teeth. You're in for a replacement arm and do tighten the nut that holds it.
Failures like this are usually the result of poor...
Lancia kappa 2nd series. Ask Martin Willems or Ted Kompas
Just measured again. From the center of the crankshaft to a piece of board laying on the black covers where they say Ferrari 456 is 450mm. That...
Sorry, forgot to say I took measurements from my 456, which has a different (lower) plenum compared to your pic.
At the front to fthe engine about 420mm, in the middle (intakes) about 30mm higher.
Not wanting to be smart, but to me this sounds as an intermittent bad contact in one of the main power leads. Like corrosion on a battery pole,...
Thanks for the tip, but I need some non-M parts that he doesn't have.