© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
Anyone have an idea what it would cost to ship it to California?
From what I saw on the wiring diagram for the 348, the dome light has one 12v wire and two grounds. One ground, (black/white) goes to the right...
At least that's what it shows in the wiring diagram for the 348.
Does the ignition key light come on? If so, the relay is good. Don't know about the 355, but in the 348, only the driver's door circuit goes...
12V on the connector that goes to the ground means you don't have a ground. The voltage travels through the light bulb filament, then to the...
Hill Engineering http://www.hill-engineering.co.uk/ferrari-miscellaneous.htm part number TS-348 for about $70. Check out No Doubt's site at...
#4 Replace the O-Ring on the Clutch Shaft. Ferrari part # 104984 [ATTACH]
Saw this on eBay. Search for item 320074740414
Thank you for all the information!!! I'm going to keep a copy in my notebook for future reference. Thanks again!
Circumference 215/50 17 = 80 inches Circumference 215/45 18 = 80.48 inches Circumference 255/50 17 = 84.95 inches Circumference 275/40 18 =...
Good, at first I thought you may have been sucking water into those two cylinders. Valve seals or oil rings. Don't know if it's a weak...
Here's some items that will break a piston. 1. Sucked valve. Valve retaining clips coming loose (usually weren't installed properly), or...
Looks like it wasn't going to be long before you needed some valve work anyway. From the photo, I see a couple of marginal valve seats. Also,...
You're probably right if this was just a regular shock mount; but since this is a coil over shock that provides the suspension for a high...
This picture was taken a couple of years ago after I picked it up. Still get the thrill every time I drive it, and that's almost daily. [ATTACH]
Dave has some great info. But yes, you will have to buy the 8mm allen socket to get those bolts loose. Just a tip, install a couple of wheel...
The fit is pretty snug. Tap on the axle flange with a brass hammer, or use a brass drift. Or you can use a hard plastic hammer. That way you...
Good plan. What about the metal you discovered in the oil? You should inspect the bottom end while you have it out. If it checks out, be sure...
WOW! Hey, I'm a true believer in repairing things too, but I wouldn't bet MY life on either of these repairs! I would be scared to death...
Sorry for your misfortune. Did you determine what REALLY failed? Belt, bearing, or tensioner? I'm betting on the water pump. Or possibly a...
