© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
At the moment, the entire market is being "re-priced" - cheap money is over. Will be interesting to see how this unfolds, there may also longer...
I doubt you can just order a new TR engine, and sounds like madness to even wanting to do so.
Can you explain the engine rebuild cost and how you reach those numbers?
And the engine must also be full of surprises, "ballooning" blocks, damaged liners, broken rings and bad pistons, all new valves... I believe the...
If a "frame off" resto is done (removing all glass, trim, replacing all rubber seals) then a paint would undoubtedly be north of 100K.
Does anyone know the (his)story on this example? It seems to be considerably below the average 512 prices - what is the reason? I am aware of...
And then you have the fact that there are over 7000 produced...
In typical BHCC fashion they hosed it down with a power washer and took pictures while still wet. Sourcing the glass along will be a very...
Was this part of the hurricane-damaged cars? Strange it has ended up for sale in this particular venue...
Rare insofar the 400/412 is concerned, probably the only one...
This is another example of "negative equity"? Cost of restoration exceeding the value of the car? 50K for the engine, 40K for the...
No affiliation. For our records....
Thank you all. Will open the switch and see what condition it is in.
Great, thank you. Do you know the pin layout to test the function?
Hello, I have removed and disassembled the throttle tower and the TPS that sits underneath, I assume this modifies the timing, as there is no...
Yes, very "bad" result for the seller. The market is very weak.
Not many 400 Carbs - does this have more HP than the 365?
I will try something abrasive and a solvent - acetone could work, but it may also melt the plastic. WIll try it on a small area and see.
Any recommendation on what to use to clean the plastic impeller? I would like to restore the bright yellow again, it has baked in grease and oil,...
I had someone do it under my direction, but to do it right would be to lift the car and remove the front valance to give full access to the lower...
