© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
That's actually not a bad dealership. (No affiliation) I've purchased parts at other dealers and for some reason, they've always had the lowest...
I need better braking. Could I, theoretically, purchase front calipers and the bigger carbon fibre rotors off a CS and improve the front braking?...
I noticed that from the header back, there are no exhaust system weight supports until the back of the trans where the muffler is mounted. There...
I had to replace my coolant filler cap because it wasn't holding pressure. Each radiator has a cooling fan, make sure you can hear them cycle on...
Everytime you open the garage door, you'll see the car you bought. If you got the car you wanted, you'll smile. If you got the better financial...
It is a Sanden SDV Compressor, and it uses PAG 46 oil.
I had to add some R-134a, but I don't know what kind of oil to use. Manual says "ISO 135 RL 150" but I can't figure out what that means? Is that a...
It's too bad that someone can't post a legitimate concern on this site without getting ridiculed. I was looking for some helpful feedback or...
There's no paint on there at all. That's what makes it so beautiful. Glass beaded aluminum is awesome. I did, however, spray about 5 layers of...
Firstly, I resent the fact that you used my personal information, entrusted to Ricambi America, to post here for everyone to know, just to further...
READ THIS. THIS I GOT STRAIGHT OFF OF HILL ENGINEERING'S SITE, IN THE CATEGORY OF COUNTERFEIT BEARINGS!: "As there are many types of Bearings...
THIS IS EXACTLY HOW THE SITE AT RICAMBI AMERICA REPRESENTS THE HILL ENGINEERING PRODUCTS IT SELLS!: "All of the parts listed below are...
Done!! And it drives exceptionally well. The trans mount really made a difference in the engine stability. I had to install a new clutch master...
Ricambi America and especially some guy on FerrariChat really pushes these Hill Engineering bearings. Now, I couldn't see the thrust bearing...
Back to work. I was installing the clutch when I noticed that it was out of round!! It's a good thing I wasn't using the clutch line-up tool, or I...
Valuable information....I was gonna guess. Thanks alot.
Excellent suggestion, yes, I already did, it was beat. And it is much nicer looking. I used my wheel bearing remover to change it out. Thanks!
Can anyone tell me torque specs for the flywheel to crank, Pressure plate to flywheel. Ring gear to pressure plate? I can't find any low $...
Okay folks, finally got around to working on clutch again. I decided to go with the Hill Engineering Thrust Bearing. So, after some cleaning of...
Yes it is. The metal washers were bent. That explains the bucking it was doing. It's on the list...$172. Thanks!
