© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
Got a pre-loved F430 last week and noticed a pretty good exhaust rattle around 4k RPM. The well known exhaust mounts are fine and the tips aren't...
Purchased CF parts instead.
I can do $300 to anyone that is interested. New they are $900 for all 4, or I could paint what I have, but if you have the parts just hanging out...
I just used this thread to track down a gas smell. Took off the engine panel and touched the top of the white fuel pump and it was slightly wet...
WTB the F430 4 piece dash trim kit that someone would have left over after putting something like the R tuned carbon 4 piece kit on their car....
I've read through the F1 clutch posts but haven't found the answer specifically for the early cars like my 99. Since there is no PIS adjustment...
I purchased the Motive PowerBleeder with the European adapter 1100. Went to plug it on and it would not screw on. It almost did, but the threads...
I'd like to buy a nice 360 car cover so after I wash her, I can keep her clean.
What broke on yours? On mine the plastic that holds the E clip that keeps it on the shaft broke, but I put some DAP Blue Stik on it and it...
Mine came from Columbia, and there was a lot of white powder coming out of the exhaust.....
Thanks everyone. The VIN decodes as a US model, so it's a 99 US car without precats. I'll stop looking at headers then.....
OK I've searched and searched but can't figure this out. I have a 99 Ferrari 360 with 9900 miles. Are all 360's in the US "Euro" cars? My VIN...
How did you get yours done? How much was it? I have a 99 US car.
wheels are sold (I bought em)
Just got a low mileage car driven just 2000 miles since last belt change 6 years ago in 2008. Took it apart first thing and found the driver side...
I just tried my Native Union handset and it raised the noise floor and the signal level by about the same amount. Either way I had 40dB of signal...
Is there a reasonably priced LocTite Threadlock that is recommended? One that helps keeps the pulley from flying off, but doesn't make a...
I'll try the heat gun trick this weekend once I get the flywheel locking tool I ordered from Ricambi. I'm just doing the belts am concerned...
Does anyone have a recommendation on a crankshaft pulley puller that can be used with the engine in the car? I've done umpteen Google searches...
I'm a EE that works in telecom and have some experience with frequencies. Just got a gorgeous 1999 360 with low mileage (9,926 miles) that I...
