© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
Does anyone know the Bosch number for the water temperature sensor found in a 87 Testarossa. I believe the Ferrari number is 121720. I believe...
I will disconnect mine for the time being and check whether my cats are functioning or not. In the meantime, have either of you taken the module...
My car is a 87 TR. The red light and buzzer came on saying that cylinders 1 - 6 were in trouble and I should slow down. Since the car was cold I...
The car is a 1987 TR.
I replaced by AC compressor. A direct replacement is Murrey 58046 $280 from O"Reilly If you plan to switch to 134A, then the fittings are...
Install an extra relay as suggested by Phillwozza and I bet your problem will go away. It did for me. There should be a post somewhere detailing...
I was not clear in my original post. The car cranked fine but did not fire. I long ago put a relay at the starter so the starter solenoid gets a...
My 87 TR would not start when I was out in Houston. The pumps were on as we felt the relays when cranking and could feel them clicking. We...
I want to thank everyone who wrote about their TR not starting. Mine died as I was backing out of the garage. I studied the wiring diagrams...
Thanks to everyone for the alternator info. I now have a larger deeper pulley and hope it works. Also thanks for the info on the KE manual. I...
Does anyone know where I can buy the Bosch manual for the KE-Jetronic manual 1 987 722 101? Or, if anyone has one, I would be glad to pay for...
Go to http://www.ebizautos.com/victorymotorcars/detail.cfm?iid=582849 to see a beautiful 1975 308 GT 4
CHANGE THEM!!! The rubber will swell from the inside and you will not have brakes on that wheel. Happened to me on the track with only ten years...
All, I finished restoring my 75 308 GT4 about two years ago. I did all of the work, motor, body work, paint, etc. I had the interior done. It...
The belt on my 75 308 GT4 needs replacing and I can not read the numbers. It is a Gates and the numbers look something like ?M925...
thanks, I am just not reading the past threads enough. I have now reread all of it. The oil temp sensor and dip stick are out and the pan is...
Thanks everyone for the advice. I have taken off th muffler, timing belts, harmonic balancer, all nuts, double nutted the bottom studs and...
Mike, you just think that the small fitting is fixed to the line. It is not, it is just rusted on. Also, the large part has a slip of metal...
I rebuilt my 75 308 GT4 several years ago and now a bearing on the shaft of the cam drive is bad. Can this case be removed without removing the...
