© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
Jon' That was great... I am going to watch it many time....I sure wish I could paint them that fast... Thank
I thought it might be interesting to post what they buried under the lead from the factory with minimal prep. Steve [ATTACH] [ATTACH]
We have the passenger lower rocker completed last week and got a jump start on some parts to body fit and surfacing. We plan to move back to the...
So true Scott. If someone has never see how it's done it's very hard to explain. I will try to photograph and show how many different bends and...
It will be very nice to finally finish the sheet metal replacement, rust repair and fit and finish.This segment is very time consuming and when...
Hey Jon... Can't we find a antenna that will hide... so we can get rid of the ugly hole in the rear quarter? Steve
We finished the sheet metal work on the front lower valance and are now starting a little metal finishing. We finished the nose and fit the...
Stuartlarman, Thank you for explaining the structural design of a cinder block. I went down to the shop after church today, and changed the block...
Thanks again for checking it out today Alberto. Good suggestion about the RR ties. Steve
Thank you very much for your concern. Going back on the rotisserie on Monday. Steve
Here are a few more pics of progress today. Attila got a tighter fit on the front nose. Got the front grille in with the first fit and some sheet...
Just to post some progress on the sheet metal work. The new front nose turned out great. Now to cut the old and original rusted and damaged nose...
From looking at the photos I picked up on the dash is not the correct material (not the mouse hair from the Netherlands) and it looks like the...
I don't know anything or anybody that doesn't like a little sun shine sometime! This Bull is taken a little time to cook in the California sun....
Just got the parts back from the walnut blaster. We seam sealed and will get in to primer quickly so they can go back on the car and we can start...
Not so scary if done properly and with the right equipment for this process. This is not a rotisserie job where you can media blast. I have soda...
This will be the last bath this Dino will ever see. Now that the surface material has all been stripped off we de-greased and pressure steam...
Jon, I don't know if you had ever seen these pic's of Oro Kelso before I brought it down to you. This is the way I picked this one up. I then took...
Thank you Matthias for helping us confirming and researching this Dino. This could be the only Oro Kelso Dino out there at this time. Even though...
All the inner fiberglass parts finished. The parts were prepped and any cracks and holes were repaired. Then a new coat of resin was brushed on to...
