© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
I copied this article, it is long Why An Expansion Of The Ethanol Scam May Ruin Your Lawnmower (and Your Weedwhacker, and Your Snowmobile,...
In a couple of weeks I will be starting my engine after a complete rebuild, new pistons, valves, inserts, bearings, etc. I am not sure what oil...
Does anyone know how much tension the cam chains should have, these engines have a mechanical adjustment system where tension is made via a bolt...
Does anyone know if there is another source, other than Ferrari, for a clutch pressure plate and disc.
I took the crankshaft to Castillo's Crankshaft Specialists in Southern California to see if I needed to have the mains, rods machined to first...
After machining the crankshaft to the first under size rod and main bearing specifications do I have to have it balanced. I had the engine parts...
I going to take my crankshaft in for machining to the smallest over size main and rod journals. What dimension in should the crankshaft rod and...
I ordered a steering rack tie rod end for my '73 246GTS and when I received it the size was larger that the stock ends. Is there any source for...
Due to worn out rack bushings I need to get the rack out of the housing. How do I remove the rack ball joint. Does anyone know the dimensions...
Thank you for the advise on how to remove the steering rack. I now have it out of the car. What I need to do now is fix the play from the...
I looked at other posts on removing the steering rack but I did not find advice about separating the steering shaft from the pinion fitting. I...
I have 10" wide 16" diameter rear wheels with 265/50 VR 16 Pirelli tires that need to be replaced due to old age. I hope that I can get a...
I used my 12 ton press to push the dowel I made and was successful in getting the rest of the 4 venturi removed from the carbs. New 34 mm venturi...
I made a wooden dowel to remove the Weber's venturi, successful on one carb. The rest won't budge. These are 36mm venturi and have been in the...
Stratos cam timing specifications for this four valve engine are: Valve lift .360 degrees, duration 274 degrees both intake and exhaust, duration...
I have always used 30wt break-in oil. After checking oil posts here and other sources, I have read about the change to oil and warnings to owners...
Last week I sucessfuly installed the Stratos 4 valve engine back in the Dino. The Weber carbs 44 IDF-27 that came with the engine have the jets...
I am getting ready to install the engine in the car but decided to pull the engine and gear box lower covers to remove old gaskets. It is best to...
After installing new head studs and nuts is it necessary to re-torque after running the engine for say 500 miles. I hope not. These are ARP...
In a few days I will be ready to install the engine back where it belongs. I would like to know how much can be assembled and not have a problem...
