© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
Thanks for the diagram. Seeing the fully disassembled pulley helps. I think the cable routing must be for a different model though. The...
Good advice for sure! The thing was I couldn't stop. I had to get the car to the point where the window would go up and stay up since I was...
I decided to tackle the driver's side window winder on my 82 308 yesterday. I eventually got the motor and cable out, and when I took it apart I...
Interesting. Thanks for the link! I'm amazed that I didn't come across this site when I searched many different way for plugs a few weeks back....
I've been looking for a good solution to delete my antenna yet ensure that it can be reinstalled later in case a future owner so chooses. The...
Mike, you totally took the steam out of my planned "I can't believe someone married Imelda Marcos" comment :) . Well played. Seriously, she's...
The wheel very neatly obscures the fuel gauge and everything on either side. So I have to peek under the wheel every so often to make sure my...
You're awesome! Thanks so much :)
My clock bezel is broken. If you're printing one up could you print another for me. I'll cover the printing cost and postage. Your project is...
If the green one isn't made with Asbestos I'd go that route. Asbestos is some nasty toxic stuff, and even though it is sealed within the material...
Perhaps it was lost by a previous owner in the distant past, or removed during a service and never reinstalled?
Is the Nick referred to in this thread "Nick's Forza Ferrari dot com"? I tried to read the page on this setup but it's incredibly tough on the...
I've seen the same residue on tranny drain plugs on Porsche 915 transmissions. It's the fine paste that comes from gears being ground over the...
Jalopnik has a love hate view on Ferrari. They love to drive and write about the cars, but they never miss a chance to gloat when one of them...
I always try to be present for at least a portion of the PPI, and usually spend at least a half hour with the mechanic going over the car from...
That helps a lot, thanks! I suppose one would have to go the internal puller route only if the bearings won't budge by tapping the inner race on...
One way to deal with forum members who deal in bad faith is to out them in a more easy to find way. On another car forum I belong to there is a...
@shashi27 Can you describe how you pulled the bearings themselves from the hub? Did you use an internal bearing puller?
Wow, that goes way beyond the poor packing of a part! Sounds like someone who has no respect for others on the board.
I've sold plenty of parts in the past, both big and small, and always packed them with great care. Even a hood ornament would get boxed, bubble...
