© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
I've been (or was) a NASCAR fan since the 60's. But 'dega ain't racin' anymore. It's reckless driving at 200 mph for 500 miles. When you have 30...
Yes, no argument there. However, when I responded to @Timmo, (my post #41), I was thinking that would be a bad idea to wire the by-pass open as...
I feel a little vindicated. :)
Yes, you are correct. My memory wasn't up to snuff. I was thinking the by-pass opened only based on RPM and gear. Checking,the manual I see it...
Either way you look at it, it's going around in circles. It's just whether that circle is completed inside or out side the exhaust system....
The OEM muffler doesn't have separate chambers for primary and secondary, just different paths. All 4 exhausts connect to the same chamber. If...
Good to know. Thanks
Thanks Brian
Hi guys. I have an 85 308 GTB QV and I want to replace the York style compressor with a new similar unit. Not a conversion to the Sanden type....
Have the cam belts been changed recently or are they 20 years old? I wouldn't be red lining the engine with old belts. You might want to do a...
I tried to watch the video but I just have a problem listening to a guy who is younger than I was when these cars were new tell me about how...
That's great. Like Steve said, that connection directly to the battery back feeds a lot f things. Does the car have any type of immobilizer? If...
Are you saying you are measuring 11+ V on the yellow wires at the coils. If that's the case something doesn't make sense. Yes. that's what I...
Wait a minute. If there is no trigger the voltage at either coil terminal should remain at 12V with the ignition on. If you are not getting 12V...
If can handle it. Repost form my post #17: Triger signal. [MEDIA]
Hi Max, I'd retest the sensors. The first 2 are probably ok but the third is not looking good. Make sure you have a good ground. The problem is...
What about Brian's comment in post #6? Have you tested the impedance of the rpm sensor? It's the same as the crank sensors.
750 ohm is in the ball park. 1 ohm sounds like you have a short in the wiring somewhere. The pins on the diagnostic connector tell you which...
The scope is a hand held unit. Diymore DSO 152 Handheld Small Oscilloscope. https://www.ebay.com/itm/356411998356? Here is 80-28.
https://www.ebay.com/itm/226692235914? https://www.ebay.com/itm/235658878327?
