© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
I don't know, It could be. PM me and I will contact the client
There isn't any in the US. GT car parts has a complete disassembled unit that needs rebuild/assembly we spent weeks looking.
Have a mondial T here that also dropped a valve and has catastrophic engine damage. This client isnt interested in spending the money to fix the...
I am interested did you install new fuel pump assemblies or new fuel pumps in the existing housings. If you did not have issues prior to the fuel...
I believe he is inquiring about the electronic values you can see in the scan tool. Keep in mind on the 360 you can only electronically monitor...
Sent you a pm. 2/3 of those parts are not 308 parts but DCT parts form the filter kit and not really worth anything. sent you an offer.
sounds like ABS is activating which is usually due to incorrect tire sizes or a weak speed sensor. the only software update is to the instrument...
You do not need to reengineer anything. Properly adjusted these will not bind. If you do not have a 8 cylinder manometer you are not going to...
Properly adjusted these will not bind.
Common issue and if it is present after doing the above items it is almost always a throttle plate binding in a throttle bore either due to miss...
That is in Bar
Yes we do that all the time.
seals are different between the two units. F1 seals will not tolerate brake fluid.
We transport 7-8 cars in every year for service from Montana. 3 are within 60 miles of Bozeman. No shortage of Ferrari's out there. They are...
Sounds like an injector issue not a distributor issue. The injector should not open or flow fuel below roughly 2.8 bar. If it is then nothing in...
458 coils should be removed and the interior of the boots blown out with compressed air annually or after any track use. Most of your coils and...
Common, we solder them back on. You will need to modify the existing connector.
All that is needed is a Proxi alignment in the body module. If your independent doesn't know this find someone else.
The failure is the clutch spring rate doesn’t pass and falls outside the small parameters given by the factory. Often you can try putting it into...
