© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
ECU repair at https://www.ecudoctors.com/ did the Immo defeat. As far as I can tell they remove the blue immo box from under the dash and then...
Im leaning that direction too. (the corrupted immo defeat direction) I sent an email of everything we have found so far to ECU repair at...
this break down helps let me double check it and see that this matches up.
Ok I was able to remove the cap from the relay and check it for voltage and action with ignition turned on and with cranking. The relay does...
Ive got 12 volts to the pins on the back of PDR1 and the relay tests fine on the bench. I also went ahead and pulled out a spark plug and cranked...
Here’s another update. Crank values in lice data. Not sure these are what should be showing [ATTACH] [ATTACH]
Ok got PDR 10 and PSR 10 checked. I checked the incoming voltage and they are both at 12 volts then I bench tested the relays themselves and the...
Scratch that, bad reading, Injectors are at 12 volts as well
found pin 2 at the MAF sensor and it has 12 volts
Checked the power at the injector with ignition on and it measured 8.5 volts. Made sure the battery was still producing 12.6 volts and it is....
checked all these fuses next to the battery and even though they have continuity, they do not have any voltage with the ignition on.
Charged the battery all night and now 12 and 16 are showing 12.5 volts on top side and bottom side of fuse. Going to check the Motronic relays now.
checked all these fuses this morning with the seats re-installed. They all show continuity but none of them are showing voltage with the ignition...
Sure I’ll try it tomorrow
This may be a silly question but can the seats being removed cause a no start?
No havnt checked the injectors, joist ordered set of mood lights
I checked the power to the top of PDF16 and it has 10 volts on the bottom and top side. What does the Motronic relay look like, which slot is it...
Got air, fuel and compression. Spark and timing are still a question mark
I think it is a extra plug used in the scud for some sort of selenoid.
