© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
Is this the inlet filter screen? It shows in the parts manual as a filtered union PN 115498. [ATTACH]
Hi, I don't think the problem has gone away just yet. I did clean the contacts on the fuse board so hope that helps. I have not been able to...
I have a new fuel pump - would it be safe to replace the old one? Does a fuel pump fail intermittantly? I replaced the fuel filter and cannot...
Thanks Mike. I measured the voltage at the battery with key off and was 12.73 volts. The measurement with key on was 12.10 volts. Do I have...
I tried this and found the supply voltage at 11.74 volts . When connected to the pump the voltage was 10.9 volts, and while cranking the start it...
Check with Bill at GT Car Parts in Phoenix. They have several cars that they use to pull parts from and would likely have a good condition used...
Hi Steve, the increased back pressure was my first thought as well so I changed the fuel filter to a new unit and still seeing the issue. In...
Hi Mike, thanks for the advice, will do that. It has not been failing right at the start, only after running for 30 sec to a minute so should be...
Two years ago I replaced my fuel pump on my '85 QV cabriolet and everything has been working fine until this week. I was driving along normally...
Hi, do you still have 1 for sale? Sent from my iPhone using FerrariChat.com mobile app
Thanks for the help and I will give him a call tomorrow. I can open up the bell housing if needed but wanted to confirm that I wasnt overlooking...
I opened the cover (item 2) in the diagram above and to me it looked like things were moving normal. I wanted to confirm if there was anything...
Hi, I wanted to give a quick update on this. I did replace the clutch slave cylinder with a brand new unit, and the old one was pretty rough and...
The instructions on the power bleeder said to put 13-15 psi into the tank. I've done it before when I replaced the master cylinder a year ago and...
I have recently replaced my clutch slave cylinder on my 85 QV 3.0 cabriolet [ATTACH] and when I tried to bleed the system with a power bleeder it...
Follow up on Spicedriver's suggestion - I put the car in 5th gear and tried to push by hand. There was a lot of resistance but I could get some...
When I push the pedal it feels like it is going into gear, and as I start to let the clutch out it sounds like the pressure plate is trying to...
I have seen the slave moving the lever on the clutch housing, but not sure how to tell if it's moving enough or not to work the clutch fully. If...
I was thinking the slave cylinder might be the reason as well. There are no oil leaks, and I do have some motion of the clutch lever. I can...
As part of my engine rebuild I put in a new clutch, pressure plate, pilot & throwout bearing, and also had the flywheel resurfaced. Is it...
