© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
Thanks for your replies, but hey..... I just put the rear seats back in having more or less finished my nice winter project! I still have to...
Hi, The leather headlining in my 456 GTA is starting to sag. I am sure I have seen some articles on here about fixing that problem, but I haven't...
Sorry I didn't reply, I got on with some other stuff., but yes the glovebox light on my GTA powered via the ignition key
Thanks for the replies, I managed to get this sorted. The bulb/lamp was fine, the first thing I checked. I used a continuity tester to trace the...
I have a UK right hand drive 456 GTA. My glove box light is not working. The lamp is fine, there is a good earth and the micro switch is working,...
Hi Sergio I know this is not the interior snap you were hoping for but I think it may be a bit more interesting than air vents.[ATTACH]
Hi, I owned 365 GTC 12461 for over 11 years, so know the car well. It was not supplied with air-conditioning from new. 330 GTC had three vents in...
Thanks for your help guys, your photo's were great and the job is done. Thanks again
I need to replace the rear brake pads on my 456 GTA, but cannot see how to remove the retaining springs. Any help much appreciated
You could try Brandoli in Italy, [email protected], they made a perfect set for my 365 GTC. Very efficient and pleasant to deal with. Good luck, Colin
My first thoughts had been to make a replacement from sheet material either by pressing or spinning, but there would almost certainly have been...
Thanks John. I turned a very small vee notch on the inside to both mark the cut out depth and also to help turn the tabs in. You can just about...
Slightly off topic, I have experienced the usual Veglia clock problems, which included damaging the bezel whilst getting it apart. I couldn't find...
Hi Bob, I don't think this will be possible with transaxle still in the car (unless anyone knows better?) because the left and right seals are...
Hi Steve, I didn't say anything earlier because you seemed to have it sorted, but I do have a mirror (never been fitted) in my GTC parts bin....
A few years ago my passenger window motor failed whilst my wife and I were on a driving holiday in Europe. Having a right hand drive car you can...
HI, I thought I should post a picture of the emergency window winder from my old 365 GTC. I am fairly sure it is original and will certainly be...
I found the best way to clean the joints is to take them off the shaft and drop them into a tub of regular heating oil, then wash with a stiff...
"If your banjo bolts and fuel rail are in good shape i.e. flat and smooth on the sealing surfaces, you should be able to get it to seal. " A...
So sorry to hear about your Dad, Mathew. I didn't know him well but first met Martin at a club meeting in about 2007 and we ended up chatting...
