© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
thank you this works perfectly.
weird thing so i tested the voltage to the D+ (yellow/greenwire) at alternator and it shows 14.2 volts. How can it show 14 volts with engine...
I used to have wiring diagram. I don’t know where it’s at now. It’s been 11 years since I even touched car. I found the old 308gt4 service manual...
And that would cause it to override key switch turning it off? Just curious. Car is charging though like 14.3 volts. I’m gonna test the wires...
So after 11 years I finally got my 1980 308gtsi running. It had some upgrades done (efi and coils). If I start the car and it just idles and I...
But this was is different. I have a set of timing belts for an 80 gtsi forgetting that I had nick forzas setup on here. If anyone is interested in...
Here is a photo with the shrink tube removed. I’m kind of thinking it’s for fuel pump
Thank you so much. I’m going to take a better photo of the brown wire tomorrow. This week I’m planning on reinstalling the engine.
After almost 10 years of my 1980 308gtsi sitting without an engine I finally got around to working on the car again. My question is about these...
Got tranny and motor out. Tranny was harder to take out than motor. Go figure, English design. I swear I scratch my head at some of the things...
Don’t see much esprit love here so I thought I’d indulge some. So after almost 10 years of my 87 HCI esprit not moving I decided to yank motor...
Very little pedal travel before stop point. Clutch pedal is firm and feels just like before pressure wise. Maybe the seals were going for a while...
I don’t know if the old master and new are the same. I bought master that is for this car. When I did clutch I cleaned but didn’t replace slave...
Nice tool. Biggest pain in butt to get that pin in. I got pin it and bled system. Now it seems clutch grabs much much higher to the top. Almost...
Can anyone tell me how to install this pin back in the clutch pedal that attaches to master cylinder? Is there some sort of trick. I just replaced...
Also another thing I figured out while I had motor out. Another fix to the sticky throttle is to replace return spring on throttle assembly. Mine...
I am trying to upload video but it is too large. Don’t know how to trim the video
Damn birds got inside garage and they were pooping all over the cars. Ordered some car covers Drove car for first time with exhaust on...
I just installed the kreissieg exhaust on my 89TR. All I can say is wow!!!! Makes it sound like an old school Ferrari from the 60s. And that’s...
as title says i developed a leak on the upper braided hose that goes fro. reservoir to cooler. Has this happened before? can it possibly need...
