© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
Really? It would be nice to hear from them as to why. It implies the F430 is a worse car in some way.
If you'd consider making F430 engine bay panels of the same quality as the diffuser I'd be a buyer for those!
Does sound like a trapped stone. I would take the wheel off and check the inside disk surface thoroughly.
Not quite. The F430 has front air intakes modelled on the Ferrari 156 F1 (aka "Sharknose"). [ATTACH]
My headers failed at 12000 miles and I've had two exhaust brackets replaced in 26000 miles.
Very subjective but I think wearing Ferrari gear when you're actualy driving a Ferrari is a bit lame. I was stuck at traffic lights in the F430...
Cheaper to buy some glasses. You'll then realise the F430 is better looking than the 360 Modena.
Can also manifest as a ticking sound during cold engine start. The noise can disappear once the exhaust heats up though.
I had the same problem. I snapped 2 studds when I removed the exhaust muffler. I needed to use tungsten carbide drill bits to drill through the...
The op already has ceramics so will have an appropriate master cylinder and brake booster.
Depends what you consider to be a problem. Mines never cost any money to fix but: 1 x refused to change up from 3rd 1 x got stuck in 5th for...
Serious enough to have it checked out by a specialist and hand the repair bill to whoever supplied you the car. It's certainly not normal.
Visibility is fine apart from the rear 3/4 view behind the passenger seat. The C pillar is pretty wide there so I've missed a car or two when...
I had the steel brakes replaced with factory OEM ceramics on my F430 recently. The dealership that fitted them had to perform the above bedding in...
Has anyone heard the California T yet? The engine in the 458 replacement will probably sound like that. Worth noting that the McLaren 12C...
Yes, you do need to be careful. It's not so much the pressure but how close you get to the paint. I use full pressure but no closer than 10...
Not wishing to turn this into a detailing thread but I'd add: Pressure washing with snow foam as an initial step to that list. If you...
On inertia reel seatbelts like yours maybe. On my harnesses (see below) they don't conform to the curve of your shoulder and are uncomfortable...
My car had the red OEM alcantara harness pads fitted but I removed them as they are too stiff and uncomfortable. IMHO they do look good though!...
Fixing F1 is simple. Remove fuel restrictions. Having watched Alonso going flat out through Cops corner at the Silverstone circuit in free...
