© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
Got that baffle :-) Luckydynes also made some polyurethane motor mounts, so the car could be more easily shifted while cornering and braking...
I had corrosion on my intakes and they were a "bit" reluctant to come off. I tried some lacquer thinner and that helped with the gasket removal....
I haven't been following this thread recently, but I think mike is using a custom rear bar. I sold mike the 25mm front bar. It is a Saner bar....
My Neice, (now a doctor) asked me after the acquisition, "why the 308"??? This set me a bit aback, because, where do you start??? It is a period...
Yes, it works. I had a local machinist mill the un-used ears to the same height, bore them and install helicoil, so I could mount the brembos...
Wheel and tire size matters too. Even with 400/350 pound springs and 22 mm bars F/R, I was catching the right front tire on the fender lip, so I...
If it is a visual thing, do what you like but if sound is a factor, listen to the exhaust with and without to see what you like best. You may be...
22207 Aluminum, as well. There is also foam along the sides of the radiator to keep the air from not doing its job. All good things to do to...
We need to know if you are going to just show the car, cruise it, drive it briskly, occasionally do a track day or really track it hard. What...
Welcome to the chat :-) Timing belts, exhaust , tires and oil are some of the all time big threads. There is absolutely no substitute for...
Some of these items may have a specified service interval, but you may want to do them "while you are in there ". Front wheel bearing pack -...
"PROVA 77" for the 308 - a constant test of my driving mechanical abilities "WES 74" for the 74 911 my dad passed to me. And, the best...
When the engine fires up, it pulls on the diaphragm, applying additional pressure. If the pedal goes down, there must be something getting...
We might look down the road just a bit. What will a PPI show up on your car and how will that entice or blow off a potential buyer. If I saw...
My first car was an MGA, Loved that car. The only car I had clutch sticking problems with was my hotrod 914.It had an aluminum 911s clutch and...
360 wheels make just about any Ferrari look better, even my 308. But shaving any metal on such a highly stressed part is something that needs...
As long as you are in there, you might as well replace the rubber seals that get hard with age. Anything to keep water and junk out of the plug...
For the earlier, non cat cars, here is a shot of one of the first flowmaster units that I copied, but added two twin pipe resonators, like Newman....
If you track the car, or just do annual brake flushes, I think it is worthwhile to alternate with different colored fluids, so that you can easily...
There are very very few cars that come from the factory with brakes big enough to run track events without fluid / pad fade and rapid wear, in...
