© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
I got my OE starter serviced. The drive was very sloppy apparently missing a bushing. We changed out the drive assembly and solenoid and tested it...
I meant to write, I should get some of those terminators. Do I need one terminator with a lead wire and one terminator without a lead wire to...
I should get some of those terminators. Do I need one with and one without terminator to bridge a but connection? I did get my geared starter out.
Mark, What other thread for the shield terminators? I really don't like the extention Weather Tech connectors. These connectors are too bulky for...
I don't believe we used an alternator, but not sure. The wire you buy looks like what I should use. Twisted pair, shielded, high temp insulation....
The new sensor appears nicely made. They use a shielded twisted pair, grounded on the plug end. I do have a 1/2 sensor with long lead but I'd have...
My 78 GTS had the 72/73/74/75 OE carb set as OE. The progression holes are difined in the Owner's Manual as 1.50, 1.15, 1.50, 1.60 and 1.80 mm...
Pin Description Wire Color 1 Coil A White 2 GPO 1 White/Black stripe 3 Magnetic Sensor Shield Bare 4 GPO 2 White/Red 5 GP I/O 3 White/Green 6 +12V...
Key off: No illumination of either LED Key on: Top LED ( basically a check engine light) solid red; Bottom LED solid green. Cranking: Top LED...
Assuming all carbs are functioning the same, I think you need to get at least a CO reading at idle and throughout the transition range. can you...
Today I found someone to rebuild my OE Bosch starter. He's says about $100 compete but parts are about 4-5 days out. The drive gear is sloppy on...
David, The car never started after being turned off and sitting a bit if I recall correctly. I was synching the carbs with a multibank manometer...
I pulled the second XDi2 from my 26R build. It's not far enough along to run in the car, only on the dyno, so not in a position to test. I took my...
Yesterday I closed the sensor gap to 0.020 inches. I then rerouted the pickup lead to provide about a 1.5 inch gap to the alternator housing. I...
It looks to me like I have two problems and a couple of ideas to mitigate them. 1. The ECU wants a wants a higher amplitude trigger signal- Go to...
We managed to get some images of the mag sensor signal while cranking. This image was taken while turning the motor over at about 120 rpm (I use a...
I got lucky and managed to persuade a friend of mine, who is an EE/CE, former college neighbor, and aerospace employee, to come over after work...
mk e, 2. Unfortuneately, I don't see anything that looks like a record function, so I may have to crank and look.
mk e It turns out the 2445B is a 4-channel scope. I spent some time looking it over and going through the operator's manual. I have four Tektronix...
Hi guys. I believe this schematic represents my mag sensor. What is not shown is the wire shield. I don't think the shield is attached to anything...
